Dwyer DLI User Manual
Page 39
39 |
P a g e
NOTE: When these features exist, a corresponding button will be displayed on the lower right side of the screen. An
Alarm Settings & Calibration button are displayed in the example on the screen above.
The following details are described as follows:
Password
If the Password doesn't exist the button will appear as
Set Password otherwise will appear as
Change Password. It allows editing the password of device. (See
Device Password
for full operating
instructions).
Alarm Settings
Select
Alarm Settings to display an alarm setting screen that will permit the alarm range to be
changed (see
Alarm Settings
for full operating instructions).
Thermocouple Type
Select
Thermocouple Type to display a thermocouple type screen to specify which type of
thermocouple is being used (see
Thermocouple Type
for full operating instructions).
Engineering Units
Select
Engineering Units to display an engineering unit screen to permit the type of units to be
displayed on the graph to be defined (see
Engineering Units
for full operating instructions).
Trigger Settings
Select
Trigger Settings to display a trigger setting screen that will permit the trigger range to be
changed (see
Trigger Settings
for full operating instructions).
Calibration
Select
Calibration to display a calibration screen to permit the device to be calibrated (see
Calibration
for full operating instructions).
Device Password
Password doesn't exist
The software will remember the device password after it has been set. The password will be asked
next time when the user analyzes the device data.