Dwyer DLI User Manual
Page 40
40 |
P a g e
Password exists
NOTE: If the device passwords exists, the password will be asked when editing the device features (
Alarm Setting
,
Thermocouple Type
,
Engineering Units
,
Trigger Settings
, Wireless Configuration, and
Calibration
) or performing
Read Device Data
,
Batch Start
,
Start Device
,
Stop Device
, and
Reset Device
. See the window below:
Thermocouple Type
Select
Thermocouple Type to display a thermocouple type window to request the input of the
thermocouple type being used. This command is only available for devices that use thermocouples as
the sensing element, such as the TC4000, TC110, QuadTemp, and OctTemp. The device will
configure itself appropriately for the chosen type of thermocouple. The device requires this
information to properly make temperature measurements and automatically perform the
thermocouple cold junction compensation. Upon activation of this command, the software
communicates with the device to determine if it has a programmable thermocouple attached. If it
does, the following window appears: