Dwyer DLI User Manual
Page 38
38 |
P a g e
Device Status Tab
The
Device Status tab displays the device type, revision number, serial number, Extender (user) ID,
and operating parameters of the particular device in the Device Status dialog box. The serial number
is set at the factory and cannot be changed by the software. The user ID can be selected when starting
the device. This command will also verify that the software is able to communicate with the device
and that the correct COM/USB port has been selected. If the device does not communicate, verify the
following:
1. Are the COM port and baud rate correct?
2. Is there another device using the selected COM port, such as a modem?
3. Is the device's battery dead?
4. Is the IFC110 cable connected to the correct COM port?
In addition, this command will read and indicate the current status and all pertinent information of
the device that is connected. This provides a quick method for determining the current state or status
of a particular device.
Device Detail Tab
The
Device Detail tab displays the details of the device. An example of a HTDL-10 data logger is
seen in the screen below:
The details include device type (device name as heading), revision number, subtype, and channel
information. Information about Device Password, Alarm Setting, Thermocouple Type, Engineering
Units, Trigger Settings, Wireless Configuration, Wrap Around, and Calibration will be displayed
when the device supports these features.