Badger Meter Vortex Meters - Manual (Page 13)

Page 11
Save Configuration - This command will cause the meter to copy any new settings from
RAM to EEPROM. At power up, settings are retrieved from EEPROM and put into opera-
tion.
Racine Federated HART Interface Utility
FL_METER
0
4
0
72
0
RWG15
Tag:
PV (Volume)
Model Number:
Analog Output Current:
Percent of Range:
Process Temperature:
Process Pressure:
ft3/min
mA
%
degF
psi
Connect Connect Update
Begin Continuous Display Update
Continuous Screen Update:
Meter In-Service:
Edit Mode:
Fixed Current Value:
Configuration Changed, Not Saved:
Password Protection:
Tools About Com Port Save/Restore Configuration Edit/In-Service Configure Meter Save/Restore Configuration
Save Configuration
Restore Factory Configuration
Restore Configuration
Restore Configuration - This command will cause the meter to over write RAM with set-
tings that were previously stored in EEPROM. Any settings that were previously stored in
RAM will be lost.
Racine Federated HART Interface Utility
FL_METER
0
4
0
72
0
RWG15
Tag:
PV (Volume)
Model Number:
Analog Output Current:
Percent of Range:
Process Temperature:
Process Pressure:
ft3/min
mA
%
degF
psi
Connect Connect Update
Begin Continuous Display Update
Continuous Screen Update:
Meter In-Service:
Edit Mode:
Fixed Current Value:
Configuration Changed, Not Saved:
Password Protection:
Tools About Com Port Save/Restore Configuration Edit/In-Service Configure Meter Save/Restore Configuration
Save Configuration
Restore Factory Configuration
Restore Configuration