Edit/in-service menu, Entering edit mode and putting meter in-service, Page 8 – Badger Meter Vortex Meters User Manual

Page 10

Page 8

eDiT/in-seRviCe Menu

Entering Edit Mode and Putting Meter In-Service

FL_METER

RWG15

Tag:

PV (Volume)

Model Number:

Analog Output Current:

Percent of Range:

Process Temperature:

Process Pressure:

ft3/min

degF

psi

Connect

Update

Begin Continuous Display Update

Racine Federated HART Interface Utility

Tools

Configure Meter

About

Com Port

Save/Restore Configuration

Edit/In-Service

Enter Edit Mode
Put Meter In Service

Put Meter In Service

Edit Mode

Indicator

Meter In-Service

Indicator

Continuous Screen Update:

Meter In-Service:

Edit Mode:

Fixed Current Value:

Configuration Changed, Not Saved:

Password Protection:

NOTE: Save the changes to EEPROM and put the meter in-service after making changes.

Entering Edit Mode - The user must put the meter in edit mode before any changes can be

made to the meter’s settings. There are two ways to enter edit mode. The first way is to click

the “Edit/In-Service” pull-down menu on the Main screen and select “Enter Edit Mode”. The

second way is to simply attempt to change the settings and the user will be prompted to enter

edit mode.

in-service indicator - The “Meter In-Service” indicator is lit when the meter is in-service. No

setting can be changed when the meter is in-service.

edit Mode indicator - The “Edit Mode” indicator is lit when the meter is in edit mode. Settings

in the meter can be changed while in edit mode, except the analog output current. It is not

changed while the meter is in edit mode, put the meter back in-service after making changes to

the meter.