West Control Solutions KS 45 - Manual (Page 55)

Inputs InP.1 and InP.2
Name Value range Description
I.Fnc function
0 no function
1 heating current input
2 External setpoint
4 2nd process value X2
6 no controller input
7 process value X1
S.tYP sensor type
0 Thermocouple type L (-100...900°C), Fe-CuNi DIN
1 Thermocouple type J (-100...1200°C), Fe-CuNi
2 Thermocouple type K (-100...1350°C), NiCr-Ni
3 Thermocouple typeN (-100...1300°C), Nicrosil-Nisil
4 Thermocouple type S (0...1760°C), PtRh-Pt10%
5 Thermocouple type R (0...1760°C), PtRh-Pt13%
6 Thermocouple type T (-200...400°C), Cu-CuNi
7 Thermocouple type C (0...2315°C), W5%Re-W26%Re
8 Thermocouple type D (0...2315°C), W3%Re-W25%Re
9 Thermocouple type Typ E (-100...1000°C), NiCr-CuNi
10 Thermocouple type Typ B (0/100...1820°C), PtRh-Pt6%
18 special thermocouple (Linearization necessary)
20 Pt100 (-200.0 ... 100,0 (150)°C)
21 Pt100 (-200.0 ... 850,0 °C)
22 Pt1000 (-200.0...850.0 °C)
23 Special 0...4500 Ohm (default as KTY11-6)
24 Special 0...450 Ohm
25 Special 0...1600 Ohm
26 Special 0...160 Ohm
30 Current 0/4...20mA
31 Current: 0...50 mA AC (HC input Inp2 only)
40 Voltage 0...10V / 2...10 V (Inp1 only)
41 Special (-2,5...115 mV)
42 Special (-25...1150 mV)
43 Special (-25...90 mV)
44 Special (-500...500 mV)
45 Special (-5...5 V) (Inp1 only)
46 Special (-10...10 V) (Inp1 only)
47 Special (-200..200 mV)
50 Potentiometer 0...160 Ohm
51 Potentiometer 0...450 Ohm
52 Potentiometer 0...1600 Ohm
53 Potentiometer 0...4500 Ohm
4wir Resistance connection type(only for Inp.1)
0 3 wire connection
1 4 wire connection
S.Lin linearization
0 no linearization
1 special linearization
Corr measured value correction
0 no correction
1 offset correction
2 2-point correction
3 scaling
In.F
OFF,
-1999...9999
alternative value INP
fAI1
(fAI2)
Forcing of analog input INP1, INP2
µ (only visible with BlueControl
Ò
!)
0 not active
1 the value for this analog input is defined via interface.
Configuration level
KS 45 55 Configurations