West Control Solutions KS 45 - Manual (Page 18)

5.4 Displays in the operating level
5.4.1 Display line 1
The displayed value, also named process value, is shown in the first display line. This value is used as controlled value
(variable). It results from the configuration
C.tYP. (also see chp./page 7-22.)
5.4.2 Display line 2
The value to be displayed continuously in the second LCD line can be selected from different values via the
BlueControl
Ò
engineering tool.
Normally the internal setpoint SP is set.
1 Default settings as setpoint
2 Display of operating mode
automatic/manual
g
By deleting the individual settings for display 2, it is resetted to setpoint display. Reset to display of the
engineering unit is possible by deleting the entry for line 2.
g
With faulty input values, signals dependent on the inputs (e.g. Inp1, Inp2, display value, Out3) also indicate FAIL.
5.4.3 Switch-over with the enter-key
By using the enter-key, different values can be called in display 2. Every time you press the enter key, the display
jumps to the next feature as shown below.
1 Displaying the defined display 2 value (via BlueControl
Ò
).
Standard setting is the internal setpoint
2 Displaying the output value, e.g. Y 57
3 Calling up the error list, if messages are supplied.
If there is more than one message with every push of
the enter key the next message is displayed.
4 Calling up the extended operating level, if messages
are supplied.
If there is more than one message with every push of
the enter key the next message is displayed.
5 Returning to the original displayed value.
If for 30 s no key is pushed, the display automatically
returns to the origin.
Operation
Displays in the operating level 18 KS 45
1 2 M E
450.3
450.0
дььь
1 2 M E
450.3
Y 57
д ььь
1
2
ф
1 2 M E
450.3
FbF.1
д ььь
3
ф
ф
ф
ф
1 2 M E
450.3
L.1
д ььь
4 ф
1 2 M E
450.3
450.0
дььь
5
ф
1 2 M E
450.3
450.0
дььь
1 2 M E
450.3
mAn
д дььь
1 2