West Control Solutions KS 45 - Manual (Page 16)

. 5 Operation
5.1 Front view
1 Line 1: process value display
2 Display 2: setpoint /output value/ unit-display / extended
operating level / errolist / values from
Conf- and
PArA-level special functions as A-M, Func, run, AdA
3 operating mode “manual”
4 Error list (2 x ô ), e.g.
· Fbf. x
sensor fault INP. X
· sht. x
short circuit INP. X
· Pol. x
wrong polarity INP. X
· Lim. x
limit value alarm
· ...
5 Increment key
6 Enter key to select extended operating level or error list
7 Status indicator LEDs
·
green: limit value 1 OK
·
green blinking:no data exchange with bus coupler
(only on instruments with optional
system interface)
·
red: limit value 1 active
· red blinking: instrument fault, configuration mistake
8 Display elements, active as bars
9 Status of switching output OUT1 active
0 Status of switching output OUT2 active
! Decrement key
§ PC connection for the BlueControl
Ò
engineering tool
g
In the first LCD-display line the measured value is shown. The second LCD-line normally shows the
setpoint. When changing over to the parameter setting, configuration or calibration level and at the
extended operating level, the parameter name and value are displayed alternately.
+
§ : To facilitate withdrawal of the PC connector from the instrument, please, press the cable left.
Operation
Front view 16 KS 45