SHIMPO FGV-XY-Series - Manual (Page 9)

-8-
Key Operation Display
Turn Power Off
PEAK ZERO ZERO
MEM MEM
UNIT
1. Hold down PEAK and UNIT.
2. Press POWER.
PEAK ZERO ZERO
MEM MEM
UNIT
3. Release POWER.
4.4 Tracking
The FGV-XY uses a load cell and strain gauge as its force sensor. The sensor is affected by environmental changes such as temperature and
humidity. The Tracking function, which is active by default, helps to negate the effects of these changes. Tracking can cause errors when
measuring very small forces. It is recommended that you turn off the Tracking function when measuring these smaller forces. With the gauge's
power off, hold PEAK and UNIT. Press POWER, and keep holding PEAK and UNIT until "oFF" is displayed. Repeat the process to turn Track-
ing back on. Instead of "oFF", "SEt" will be displayed.
Splash Screen
Tracking OFF
Tracking ON
Standard Measuring Mode
Release PEAK and UNIT
after the display shows
"SEt" or "oFF".
4.5 Functions
Key operation Display
Turn power off
PEAK ZERO
MEM MEM
UNIT
1. Hold down ZERO.
2. Press POWER.
PEAK ZERO
MEM MEM
UNIT
3. Release POWER.
Splash Screen Function Mode
Release ZERO after the
display shows "f01".
The following settings are available in Function mode.
Setting Unit Options Default
Measurement Polarity f01 -0001(minus), 0001 (plus) 0001
Display Update Time f02 1, 2, 3, 5, 10, 20 (times/second) 3
Auto Power Off f03 10 (10 minutes), oFF (always on) 10
RS-232C Baud Rate f04 2400, 4800, 9600, 19200 bps 2400
Response Time f05 3, 20, 150 (msec) 3
Output Type f06 ovEr, Hi-Lo ovEr
1.
2.
1.
2.
FGV
FGV
PEAKPEAK
UNITUNIT POWER
POWER
PEAKPEAK
UNITUNIT
ZEROZERO
POWER
POWER
ZEROZERO