SHIMPO FGV-XY-Series - Manual (Page 24)

-23-
Key operation Display
Turn power off
PEAK PEAK ZERO
MEM
UNIT
1. Hold down MEN key
2. Press POWER key
PEAK PEAK ZERO
MEM
UNIT
Release POWER
MEM Exits statistic mode, and returns to memory blocks.
PEAK Transfers the recorded memory data via RS232C, and exits memory mode.
Powers off the FGV-XY.
Memory Block Recorded Value
Positive Maximum Negative Maximum Positive Minimum
UNIT
UNIT
Negative Minimum
UNIT
UNIT UNIT
5.7.3.2 Statistics Memory Data
UNIT
Negative Peak
Positive Peak
1. When in memory mode, UNIT will cycle through the available statistics data.
2. Each press of UNIT will switch between the following items: positive maximum value, negative maximum value, positive minimum value,
negative minimum value, positive peak value, and negative peak value.
3. Press MEM to exit to the recorded measurement values.
4. Press PEAK key to output the recorded memory via RS-232C. Refer to section 6.2 regarding RS232C communication.
5.8 Clearing the Memory
5.8.1 Clearing the Last Record
1. The last recorded memory block may be erased by pressing ZERO while viewing the last data point.
2. If ZERO is pressed while viewing any other data point, the display will show "Err", and will not delete anything.
Key operation Display
Turn power off
PEAK PEAK ZERO
MEM
UNIT
1. Hold MEM
2. Press POWER
PEAK PEAK ZERO
MEM
UNIT
Release POWER
ZERO
Not the last
memory block
Value Cleared
Error
Last Memory Block
Memory block number
Memory data
UNIT
Display statistical data
Release MEM after
"CNT" is displayed.
1.
1.
2.
2.
MEMORY
MEMORY
MEMORY
MEMORY
MEMORY
MEMORY
POWER
POWER
MEMORY
MEMORY
POWER
POWER
MEMORY
MEMORY
POWER
POWER
PEAKPEAK
ZEROZERO
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT UNITUNIT