SHIMPO FGV-XY-Series - Manual (Page 19)

-18-
Key operation Display
Turn power off.
PEAK PEAK ZERO
MEM
UNIT
1. Hold down MEM
2. Press POWER
PEAK PEAK ZERO
MEM
UNIT
3. Release POWER
ZERO Deletes the current data block, but only if you have the last block selected.
UNIT
Cycles through the available statistics.
PEAK Transfers the recorded memory data via RS232C, and exits memory mode.
Powers down the FGV-XY.
5.7 Reviewing Memory Data
5.7.1 Continuous Mode Memory
1. Turn the POWER off. Press MEM and hold, then press and release POWER. Release MEM when you see "CNT" on the display. The unit will alter-
nate between showing the data block number, and the recorded measurement value of that block.
2. Press MEM to review the previous data block recorded.
3. Press UNIT to cycle through the available recorded statistics. In Continuous mode the available statistics are as follows: positive maximum
value, negative maximum value, positive minimum value, negative minimum value, positive peak value, negative peak value, average value, stan-
dard deviation. This is covered in greater detail in the next section, 5.7.1.2.
4. Press PEAK to output the recorded memory via RS-232C. Refer to section 6.2 regarding RS232C communication.
Last memory number First memory block
MEM MEM
Release MEM after "CNT"
is displayed.
1.
2.
MEM
Previous memory
5.7.1.1 Accessing Memory Data
MEMORY
MEMORY
MEMORY MEMORY
POWER
POWER
MEM MEM MEM MEMORY
MEMORY
MEMORY
MEMORY MEMORY
MEMORY
POWER
POWER
PEAKPEAK
UNITUNIT
ZEROZERO