beautypg.com

Key operation display – SHIMPO FGV-XY-Series User Manual

Page 21

background image

-20-

Key operation

Display

Turn power off

PEAK

PEAK

ZERO

MEM

UNIT

1. Hold down MEM

2. Press POWER

PEAK

PEAK

ZERO

MEM

UNIT

Release POWER

ZERO

Deletes the current data block, but only if you have the last block selected.

UNIT

Cycles through the available statistics.

PEAK

Transfers the recorded memory data via RS232C, and exits memory mode.

Powers down the FGV-XY.

5.7.2 Single Mode Memory

5.7.2.1 Accessing Memory Data

MEM

MEM

Last memory block

Previous memory block

First memory block

1. Turn the POWER off. Press MEM and hold, then press and release POWER. Release MEM when you see "SIg" on the display. The unit will

alternate between showing the data block number and the recorded measurement value of that block.

2. Press MEM to review the previous data block recorded.

3. Press UNIT to cycle through the available recorded statistics. In Single mode the available statistics are as follows: positive maximum value,

negative maximum value, positive minimum value, negative minimum value, average value, standard deviation. This is covered in greater detail in
the next section, 5.7.2.2.

4. Press PEAK to output the recorded memory via RS-232C. Refer to section 6.2 regarding RS232C communication.

Release MEM after the

display shows "CNT".

MEM

1.

2.

MEMORY

MEMORY

MEMORY

MEMORY

POWER

POWER

MEM

MEM

MEMORY

MEMORY

MEM

MEM

MEMORY

MEMORY

MEM

MEM

MEMORY

MEMORY

PEAKPEAK

UNITUNIT

ZEROZERO

POWER

POWER