2 statistics data, Key operation display, Display statistical data – SHIMPO FGV-XY-Series User Manual
Page 20

-19-
5.7.1.2 Statistics Data
1. When in memory mode, UNIT will cycle through the available statistics data.
2. Each press of UNIT will switch between the following items: positive maximum value, negative maximum value, positive minimum value, nega-
tive minimum value, positive peak value, negative peak value, average value, standard deviation.
3. Press MEM to exit to the recorded measurement values.
4. Press PEAK key to output the recorded memory via RS-232C. Refer to section 6.2 regarding RS232C communication.
Key operation
Display
Turn power off
PEAK
PEAK
ZERO
MEM
UNIT
1. Hold down MEM
2. Press POWER
PEAK
PEAK
ZERO
MEM
UNIT
3. Release POWER
MEM
Exits statistic mode, and returns to memory blocks.
PEAK
Transfers the recorded memory data via RS232C, and exits memory mode.
Powers off the FGV-XY.
Positive Maximum
Negative Maximum
Positive Minimum
Standard deviation
UNIT
UNIT
UNIT
UNIT
UNIT
UNIT
UNIT
UNIT
Negative Minimum
Positive Peak
Negative Peak
Average
Memory block number
Memory data
UNIT
Display statistical data
Release MEM when
"CNT" is displayed.
MEM
1.
2.
MEMORY
MEMORY
MEMORY
MEMORY
POWER
POWER
POWER
POWER
PEAKPEAK
MEM
MEM
MEMORY
MEMORY
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
UNITUNIT
MEM
MEM
MEMORY
MEMORY