MAGURA RADIAL 195 - Manual (Page 32)

32
BraKe disc
The brake disc is a wear part. On the outer ring the minimum thickness is given as
MinTH = 3.5 mm. If this thickness is reached the brake disc must be exchanged since otherwise
no guarantee can be accepted with respect to service life or braking performance.
caUtion: Exchange brake disc when the minimum thickness is reached or if severe
striations are visible on the surface.
caUtion: It is not permissible to only change the outer ring since the inner ring will also
be correspondingly worn.
caUtion: If the brake disc has to be exchanged the brake pads should also be exchanged.
troUble shootinG
radial superMoto BraKesysteM
ProbleM
Poor braking performance
Soft pressure point
caUse
Brakes not “run in”
Disc/pads oily
Air in system
System leaking
Air in system
System leaking
Defective brake tube
rectification
“Run-in” brakes (Page 20).
Clean disc with brake cleaner,
replace pads and run-in
(do not reuse oily pads!!).
Bleed brakes (Page 23). Check
connections and brake tubes;
replace if necessary and refill
brakes (Page 23).
Bleed brakes (Page 23). Check
connections and brake tubes;
replace if necessary and refill
brakes (Page 23). Check
whether the brake tube has
become dented or if brake fluid
is visible under the transparent
protective sheath.