KROHNE CARGOMASTER - Manual (Page 41)

CARGOMASTER®5
41 - Operators Manual
Draft values.)
GZ - curve The GZ-curve shows GZ for different angles of List
GZ : distance from center of Gravity (G) to Z
The GZ section shows the calculated area under the GZ-
curve for 0-30 degrees, 30-40 degrees and for 0-40 degrees.
Max GZ and the corresponding heel angle as well as GZ at
30 degrees heel angle are also shown.
Click on the graph to see tabulated data in a separate
window.
Calculated
Drafts
The calculated Drafts fore, aft and midship port, starboard
and center are shown on the schematic ship.
Note: The Loadcalc result “Sufficient” or “Insufficient” stability is indicated in the upper right
corner of the picture. In the upper left corner, a text indicates whether the condition calculated
is in Online or Planning mode.
Hull Stress
In this picture, the operator may choose to display Hull Stress values in
different ways by selecting Numerics, ValueGraph or % Graph. The display
selector is located in the upper right corner of the picture.
The Operator can also select whether to display sea or harbor limits for
shearing force and bending moment.
The Numerics view shows shearing forces and bending moments both in
absolute values and as percentage of the limit values. The limit values are
given as Sag or Hog maximum for a selected number of frames of the ship.
The ValueGraph option displays the bend/shear forces with the currently
selected weight unit. The operator can choose to display either Seagoing or
Harbor limits.
The %Graph option only shows percentages of the maximum limits.