KROHNE OPTIBAR PC 5060 C EN - Manual (Page 86)

8
DESCRIPTION OF HART INTERFACE
86
OPTIBAR PC 5060 C
www.krohne.com 04/2014 - 4003437201 - MA OPTIBAR PC 5060 C R01 en
8.3 Connection variants
The signal converter is a 2-wire device with a passive 4...20 mA current output and a HART ®
interface.
• Point-to-Point is supported Point-to-Point is supported Point-to-Point is supported Point-to-Point is supported
In conventional point-to-point operation, the signal converter communicates as a slave with
the master.
• Multidrop mode is supported Multidrop mode is supported Multidrop mode is supported Multidrop mode is supported
In a multidrop communication system, more than 2 devices are connected to a common
transmission cable.
• Burst mode is not supported Burst mode is not supported Burst mode is not supported Burst mode is not supported
In the burst operation a slave device transfers cyclic pre-defined response telegrams, to get a
higher rate of data transfer.
There are two ways of using the HART ® communication:
• as Point-to-Point connection and
• as multidrop connection, with 2-wire connection.
.book Page 86 Friday, May 2, 2014 12:49 PM