KROHNE OPTIBAR PC 5060 C EN - Manual (Page 6)

1
SAFETY INSTRUCTIONS
6
OPTIBAR PC 5060 C
www.krohne.com 04/2014 - 4003437201 - MA OPTIBAR PC 5060 C R01 en
Safety instructions
1.1 Intended use
The OPTIBAR PC 5060 C process pressure transmitter is suitable for measuring the process
pressure and level of gases, vapours and liquids. The available measuring ranges and permitted
maximum working pressures for each are indicated on the nameplate and described in the refer
to
Technical data on page 59 section. To observe the intended use, adhere to the following
points:
• Observe the instructions in this document.
• Comply with the technical specifications (for further information refer to
Technical data on
page 59).
• Only suitably qualified personnel may install and operate the device.
• Observe the generally accepted standards of good practice.
DANGER!
For devices used in hazardous areas, additional safety instructions apply.
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and
corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
CAUTION!
•
Any modification to the device, including drilling, sawing, trimming, welding and soldering of
parts, or partially painting over or coating, is prohibited.
• Neither is it permitted to use the device as a climbing aid e.g. for installation purposes, as a
holder for cables, pipes or other loads.
• The mounting or installation of parts is only permitted as described in this document, or
insofar as it has been authorised by the manufacturer or a certified service partner.
.book Page 6 Friday, May 2, 2014 12:49 PM