KROHNE OPTIFLEX 1100C EN - Manual (Page 44)

6
OPERATION
44
OPTIFLEX 1100 C
www.krohne.com 01/2012 - 4001721801 - HB OPTIFLEX 1100 R01 en
C. Service menu
D. Master menu
6.4 Further information on device configuration
6.4.1 Quick Setup
Use this procedure to change the probe length and give the top and bottom measuring limits.
«
xx » in the illustrations shows that you can change the value or the parameter. Push the
keypad buttons in the correct sequence:
2.9.3 RESTART This menu item starts the
device again.
YES, NO NO
2.10.0 HISTORY This sub-menu shows device
performance data (error log
etc.).
2.10.1 ERROR
RECORD
A log of device errors. Press [>>>>]
to read the errors. Press [ ] or
[ ] to scroll up or down the
list. Each error is identified by
a code. Press [>>>>] again to show
the number of incidents and the
time since the last incident in
days, hours, minutes and
seconds. For more data on
errors, refer to Status and
error messages on page 53.
Read only.
1 Depends on the probe type. Single cable Ø2 mm / 0.08¨: 20 m / 32.8 ft. Single cable Ø4 mm / 0.15¨: 10 m / 65.6 ft. Co-
axial: Depends on the number of probe segments.
2 Units and range depend on the output function and length unit selected
Menu
No. Function Function description Selection list Default
3.0.0 SERVICE Advanced settings. The settings
in this menu are protected with
a password. Only approved
personnel can change the
parameters in this menu. For
more data, contact your local
sales office.
Menu
No. Function Function description Selection list Default
4.0.0 MASTER Factory settings. The settings
in this menu are protected with
a password. Only approved
personnel can change the
parameters in this menu. For
more data, contact your local
sales office.
Menu
No. Function Function description Selection list Default