KROHNE OPTIFLEX 1100C EN - Manual (Page 23)

INSTALLATION
3
23
OPTIFLEX 1100 C
www.krohne.com 01/2012 - 4001721801 - HB OPTIFLEX 1100 R01 en
3.3.3 How to assemble a single cable probe
• Attach a lock nut 3 to the fitting below the process connection 1.
• Attach a lock nut 3 to the fitting at the top of the probe 2.
• Attach the union nut 4 to the fitting at the top of the probe. Use two 8 mm wrenches to tighten
the lock nut and union nut.
• Use the union nut to attach the probe to the fitting below the process connection. Use two
8 mm wrenches to tighten the top lock nut and union nut.
Attach the probe to the converter
Figure 3-20: How to assemble the Ø4 mm / 0.15¨ single cable probe: part 1
1 Converter and process connection
2 Probe
3 Lock nut
4 Union nut