Operation, 1 user modes 6.2 normal mode, 3 configuration mode – KROHNE OPTIFLEX 1100C EN User Manual

Page 37

OPERATION

OPTIFLEX 1100 C

www.krohne.com

01/2012 - 4001721801 - HB OPTIFLEX 1100 R01 en

6.1 User modes

6.2 Normal mode

This mode shows measurement data. Use the table that follows:

• for the selection of the measurement name (level, distance, percentage, conversion),
• for the selection of the measurement units and
• to get access to the configuration mode (INFORMATION and SUPERVISOR menus)

Some data will only be available if the device has the correct parameters entered in the
configuration mode.

6.3 Configuration mode

6.3.1 General notes

Change the settings of your device in Configuration

Configuration

Configuration mode. Data about the menus is given on page

38. You can:

• Use the 1.0.0 QUICK SETUP

1.0.0 QUICK SETUP

1.0.0 QUICK SETUP menu to commission the device. For more data about the Quick

Setup menu, refer to Table 1. Quick Setup.

• Use the 2.0.0 SUPERVISOR

2.0.0 SUPERVISOR

2.0.0 SUPERVISOR menu to read settings, device software versions and error

records, run diagnostic tests, set up a conversion table for volume or mass measurement,
change critical parameters for difficult process conditions, reset the device and change
basic parameters (tank height etc.), output settings etc. For more data about the Supervisor
menu, refer to Table 2. Supervisor.

Normal mode

This mode displays measurement data. For more data, refer to

Normal

mode

on page 37.

Configuration mode

Use this mode to view parameters, commission the device, create tables
for volume or mass measurement, change critical values to measure in
difficult process conditions. To get access to supervisor menu, refer to

Protection of the device settings

on page 47. For more data on menu items,

refer to

Function description

on page 38.

INFORMATION!
It is not possible to enter the 3.0.0 SERVICE and 4.0.0 MASTER menus. These menus are for
factory calibration and qualified service personnel only.