KROHNE Summit 8800 Vol 1 - Manual (Page 64)

64 www.krohne.com 08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 FIELD DEVICE CONNECTION 06
6 .1 .4 Analog Transmitter Input Connections
NOTE:
Only available when analog I/O board fitted.
Any analog inputs used are generally used for connection to 4-20mA type transmitters for mea-
surement of pressure, temperature or similar.
Refer to the transmitter operating manual for installation procedures.
A typical method of connecting transmitters is shown in the figure below and for the terminal
pin designations refer to the analog I/O board connection in section 7.1 of this chapter
Figure 61 Typical analog input connections
Figure 62 Analog input active transmitter loop