KROHNE Summit 8800 Vol 1 - Manual (Page 41)

41 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
I/O Analog
Input
Digital
Input
HART
Input
Analog
Output
Digital
Output
PRT Select-
able*
Serial USB Ethernet
Board
Analog
*4 5 1 3 *5 1 2 1 - -
Digital 1 - 5 2 2 5 1 - 1 - -
Digital 2 - 4 2 4 6 - - 1 - -
Switch - 12 - - 12 - *6 1 - -
Single
comms
- - - - - - - 3 - 1
Dual
Comms
- - - - - - - 3 - 2
DSfG** 4 1
Table 2 Boards with available Inputs & Outputs
*Selectable explanation
Analog: 2x digital outputs or 2 analog inputs
Switch: 6x digital inputs or 6 digital outputs
** Please note that the DSfG board is dedicated to the German DSfG protocol only.
5 .4 .2 Terminal Connectors
The input transmitter circuits are connected to the SUMMIT 8800 via the 36-pole terminal con-
nections on the rear panel of the flow computer. Before any of transmitters are connected, refer
to the instrument instruction manual applicable to the individual transmitter.
Connection methods are simply a basic indication of how the devices can be connected together.
Warning:
In hazardous environments a transmitter must be connected in accordance with the safety cer-
tificate conditions specified for the individual transmitter.
Tension clamps are used in the SUMMIT 8800. This means that the wires can be inserted without
the need of a screw driver.
Figure 29 Illustration method of cable insertion into clamp