KROHNE Summit 8800 Vol 1 - Manual (Page 35)

35 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
• Re-fitting is the reverse of this procedure.
When refitting, care should be taken to ensure that all terminals, switches and connectors pro-
trude through the rear panel and are not trapped behind it before tightening the fixing screws.
Figure 18 Rear panel of SUMMIT 8800 and removal screws
5 .2 .2 Rear panel Mode Switches
On the rear panel there are 4 Mode or Function switches located on the Auxiliary board. These
switches determine the basic operating mode of the SUMMIT 8800.
The designation and function of the mode switches is as follows:
Switch ON OFF
1 Run Mode Boot Mode
2 No function -
3 Security 2 On Security 2 Off
4 Security 3 On Security 3 Off
Switch 3 Switch 4 Security mode
OFF OFF Open
OFF ON Partial
ON OFF Partial
ON ON Full
Figure 19 Mode Switch settings
The switches control the operation mode of the SUMMIT 8800:
Run mode Used for normal operation of the computer
Boot mode Boot Mode should only be used for uploading new firmware Versions in conjunction
with the supplied Windows operating software
They also control the security level of the SUMMIT 8800: