KROHNE Summit 8800 Vol 1 - Manual (Page 34)

34 www.krohne.com 08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
5. Hardware Details
5 .1 Front Panel
The front panel of the SUMMIT 8800 is a clean and simple design utilising a 5.7” VGA touch
screen, an optical rotary dial for navigation, five LED’s and front USB port for ease of communi-
cation.
Clean the Front Panel Touch Screen with water moist cloth only.
Figure 17 Front panel of SUMMIT 8800 & USB port
5 .1 .1 Associated software
The programming port on the front panel is a standard USB type B version. The programming
port is used for the transfer of configuration and setup data and for downloading of results,
tables and report data. See Chapter: Configuration Software.
When new firmware (operating software) is required for the unit or one of the boards, updates
can be performed via the USB port and using the firmware wizard software. More information on
this software can be found in Chapter: Firmware.
When people are trained in a class room environment on the use of a SUMMIT 8800 flow com-
puter, the flow computer screen data can be forwarded to a laptop and can then be projected on
a large screen via the USB SUMMIT 8800 display monitor software. See Chapter: Display Moni-
tor.
If an optional dual Ethernet is available, a web site can be used that mimics the SUMMIT 8800
display but also enables to get alarm, audit log and parameter data. See Chapter: Web Access.
5 .2 Rear Panel
5 .2 .1 Removal of the Rear Panel
• Remove all cables and plug in connectors from the sockets on the rear of the SUMMIT 8800.
• Remove the 4 cross screws at each corner.
• Carefully pull the rear panel away from the chassis.