KROHNE Summit 8800 Vol 1 - Manual (Page 31)

31 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 INSTALLATION AND REPLACEMENT 04
Figure 13 Configurator good and bad battery indicator
Illustration of bad battery as shown on the front panel of the SUMMIT 8800:
Figure 14 Bad battery indicator on front panel
NOTE: When the battery is missing or requires replacement the flashing battery symbol as
above shown adjacent to the Time and Date on all display screens. When the Battery is within
operating parameters no symbol is shown.
4 .2 .5 .1 Copy and Restore Main Totals
After switching off the power, the totals will be lost and cannot be recalled from memory any-
more.
Therefore the user must first take note of all totalizer values before switching off the power to
the SUMMIT 8800 and replace a backup battery
The totals can be read but cannot be preset or changed via the front screen, this can only be
done by using the Configurator.
• So before replacing the battery, make a copy of all totals.
• After replacing the battery, load the application into the Configurator software (see load setup
in Chapter Configuration Software: Working with Configuration Setups). Under stream/Totals,
populate the preset totals with the last total and download the application to the SUMMIT
8800.
The totalizers should only be restored when replacing the backup battery or in extreme cases.