beautypg.com

Safety instructions, Safety symbols, Safety guidelines – GW Instek PSH-A Series 360W User Manual User Manual

Page 3

background image

Safety

Instructions

5

Safety Instructions

This chapter contains important safety
instructions that must be followed when
operating PSH and when keeping it in storage.
Read the following before any operation to

insure safety and to keep the best condition for
PSH.

Safety Symbols

Safety Symbols ......................................... 6

Safety
Guidelines

Safety Guidelines....................................... 6

Power Supply ............................................ 7

Fuse ........................................................ 7

Cleaning PSH ............................................ 7

Operation Environment............................... 8

Storage Environment ................................. 8

Power cord

Power cord for the United Kingdom .............. 9

PSH

User

Manual

6

Safety Symbols

These safety symbols may appear in this manual or on PSH.

WARNING

Warning: Identifies conditions or practices that

could result in injury or loss of life.

CAUTION

Caution: Identifies conditions or practices that
could result in damage to PSH or to other
properties.

DANGER High Voltage

Attention Refer to Manual

Protective Conductor Terminal

Earth (ground) Terminal

Safety Guidelines

Do not place any heavy object on PSH.

Avoid severe impacts or rough handling that
leads to damaging PSH.

Do not discharge static electricity to PSH.

Do not block or obstruct cooling fan vent

opening.

Do not perform measurements at power source
and building installation site (Note below).

Do not disassemble PSH unless you are
qualified as service personnel.

General
Guideline

CAUTION

(Note) EN 61010-1:2001 specifies the measurement
categories and their requirements as follows. PSH falls
under category II.
Measurement category IV is for measurement performed