GW Instek PSH-A Series 360W User Manual - Manual (Page 26)

Panel Operation
51
Buzzer sound Setting
Operation
1. Press the Menu key
MENU
repeatedly until the Buzzer menu
appears.
Set Buzzer
OFF
OCP OUT
CV 2.58V 2.01A
2. Use the wheel knob to change
the buzzer setting to ON (or OFF).
3. Press the Iset/Vset/Enter key to
confirm the value.
Set Buzzer
ON
Buzzer
condition When “Set Buzzer ON”, the buzzer sounds under
the following conditions.
* When pressing the panel keys
* When the value setting exceeds the limit
PSH User Manual
52
Remote Operation
This chapter describes the IEEE 488.2 based
remote control configuration, command syntax,
and command set overview. For further
descriptions and examples, refer to the
programming manual.
Interface
configuration RS232 (Standard).................................... 53
GPIB (Optional) ....................................... 55
Interface functionality check ..................... 56
Command set Command Syntax .................................... 57
General commands .................................. 58
Status commands .................................... 59
Miscellaneous commands.......................... 60