GW Instek PSH-A Series 360W User Manual - Manual (Page 10)

PSH Overview
19
Display
Default
display Display mode
RMT ADRS OCP OUT
CV 10.10V 36.10A
A B C D
E F G
Editing mode
OCP
SET 10.10V 36.10A
A B C D
E F G
A RMT: remote control mode
(Nothing): panel operation mode
Not available in editing mode
B ADRS: RS-232 or GPIB address (available
in remote control)
Not available in editing mode
C OCP: Output Current Protection On
(Nothing): Output Current Protection Off
D OUT: Output On
(Nothing): Output Off
Not available in editing mode
E CV/CC: Current and Voltage display
mode (Constant Voltage/ Constant
Current)
SET: Current and Voltage editing mode
F Output Voltage readback value (display
mode)
Output Voltage setting value (editing
mode)
G Output Current readback value (display
mode)
Output Current setting value (editing
mode)
PSH User Manual
20
Display (cont.)
Menu mode
display The following displays appear when pressing the
Menu key
MENU . To move to the next configuration,
press the Menu key repeatedly. When inactive for
more than 5 seconds, the display goes back to the
default mode.
(Default display)
Output Voltage
Protection setting.
For details, see
page48.
Output Current
Protection setting.
For details, see
page49.
Display contrast
setting. For details,
see page50.
Buzzer setting. For
details, see page51.
Set OVP
21.10V
Set OCP
ON (OFF)
Set Contrast
70%
Set Buzzer
ON (OFF)
Interface RS232
Baud Rate 9600
OCP OUT
CV 2.58V 2.01A
Remote control
interface setting. For
details, see page52.