Panel operation, Menu key overview – GW Instek PSH-A Series 360W User Manual User Manual
Page 22
Panel
Operation
43
Panel Operation
This chapter describes the manual operations
done at the front panel, together with the
constant voltage/ constant current crossover
characteristics.
Menu key
overview
Menu Key Overview ................................. 44
CV/ CC
characteristic
Constant Voltage/ Constant Current Crossover
Characteristic .......................................... 45
Output Voltage
setting
Output Voltage Setting ............................. 46
Output Current
setting
Output Current Setting ............................. 47
Note ...................................................... 47
OVP setting
Set the OVP value.................................... 48
Clear OVP error ....................................... 48
OCP setting
Turn the OCP On/Off ................................ 49
Clear OCP error ....................................... 49
Display contrast
setting
Display Contrast Setting ........................... 50
Buzzer sound
setting
Buzzer sound Setting ............................... 51
Buzzer condition ...................................... 51
PSH
User
Manual
44
Menu Key Overview
Press the Menu key
MENU
. To move to the next item, press the
Menu key repeatedly.
Default display
Output Voltage Protection setting
To set the value, use the wheel
knob
.
To select the editing point (before or
after the decimal point), press the
F/C key
F/C
repeatedly.
Output Current Protection setting
To enable or disable OCP, use the
wheel knob
. When enabled,
“OCP” appears on the default
display.
Display contrast setting
To set the display contrast, use the
wheel knob
.
Turn right: increases contrast
Turn left: decreases contrast
Buzzer setting
To enable or disable buzzer sound,
use the wheel knob. The buzzer
sounds when trying to set a value
beyond the specification.
Set OVP
* 21.10V
Set OCP
* ON (OFF)
Set Contrast
* 70%
Set Buzzer
* ON (OFF)
Interface RS232
Baud Rate 9600
OCP OUT
CV
2.58V
2.01A
Remote control interface setting
RS232 (standard): To set the baud
rate, use the wheel knob
.
GPIB (optional): To set the GPIB
address, use the wheel knob
.