GW Instek PSH-A Series 360W User Manual - Manual (Page 16)

Setup
31
Load Wire Assembly (cont.)
4. Terminal
cover assembly Screw the output terminal cover to the rear
panel.
5. Wire shield
connection
(recommended) Connect the load wire shield to the rear panel
ground connector.
PSH User Manual
32
Remote Sensing Wire Assembly
Select the appropriate wire according to the guideline on page25.
Local sensing The sense terminal is connected to the output
monitor terminal with bare wires.
Remote Sensing 1. Take off the wire jumpers.
2. Screw wires to the sense (S) side.
CAUTION
• Do not screw remote sensing wires to the
monitor (M) side.
• M+, M− are for output monitoring only. NEVER
screw load wires to the remote sensing
terminal.