SilentKnight VisorAlarm ARLY Interface - Manual (Page 63)

VISOR ALARM – ARLY Configuration
II - 58
Doc.DM359-I
Rev.2.0
Example:
ARLY-1 Cfg> MIP 77889900 MNT-PASSWORD 12XYZ00BZ
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO MIP accnt MNT-PASSWORD password
t) UPDATE MIP accnt LOCAL-IP-PARAMETERS
This command programs the mIP/IPDACT IP parameters. Using this command the IP address, mask
and gateway can be programmed at once.
Syntax:
ARLY-1 Cfg>UPDATE MIP accnt LOCAL-IP-PARAMETERS ip-address mask gateway
IP-Address IP Address of the mIP/IPDACT ethernet interface.
Mask Network mask for the mIP/IPDACT.
Gateway Internet Gateway IP Address.
Example:
ARLY-1 Cfg>UPDATE MIP 77889900 LOCAL-IP-PARAMETERS 192.168.1.200 255.255.255.0
192.168.1.1
ARLY-1 Cfg>
u) UPDATE MIP accnt PSTN-ACTION
This parameter sets the action that a mIP/IPDACT must carry out when a supervision failure
in its PSTN input is detected.
Syntax:
ARLY-1 Cfg>UPDATE MIP accnt PSTN-ACTION action
Action NONE-ACTION: Do nothing
SEND-ALARM: A Telco-1 trouble signal is sent
OUTPUT-ACTIVATION: The output is activated
BOTH-ALARM-OUTPUT: Both actions are carried out.
Example:
ARLY-1 Cfg>UPDATE MIP 77889900 PSTN-ACTION BOTH-ALARM-OUTPUT
ARLY-1 Cfg>
v) UPDATE MIP accnt SUBSCRIBER-TELEPHONE
Only available for mIP/IPDACT command.