SilentKnight VisorAlarm ARLY Interface - Manual (Page 48)

VISOR ALARM – ARLY Configuration
II - 43
Doc.DM359-I
Rev.2.0
Example:
ARLY-1 Cfg>MIP 101234 BCK-KEEP-ALIVE-RETRIES 30
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO MIP accnt BCK-KEEP-ALIVE-RETRIES num_times
p) MIP accnt BCK-KEEP-ALIVE-RETRIES-TIMER
This parameter is the same as the keep-alive-retries-timer however it is applied to the
backup VisorALARM.
Syntax:
ARLY-1 Cfg>MIP accnt BCK-KEEP-ALIVE-RETRIES-TIMER time
time Time in seconds between keep-alive frames when a possible
connectivity failure has been detected. Admits values between 3 and
9.
Example:
ARLY-1 Cfg>MIP 101234 BCK-KEEP-ALIVE-RETRIES-TIMER 3
ARLY-1 Cfg
>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO MIP accnt BCK-KEEP-ALIVE-RETRIES-TIMER time
q) MIP accnt RESET
This command does not handle configuration but restarts the mIP/IPDACT with account accnt.
Syntax:
ARLY-1 Cfg>MIP accnt RESET
Example:
ARLY-1 Cfg>MIP 101234 RESET
ARLY-1 Cfg>
r) MIP accnt LOCAL-EVENTS-ZONE
This parameter defines the base number for the zone field that will be appear in all the events
generated by a mIP/IPDACT that does not come from the Alarm Panel. This parameter is not sent to
the mIP/IPDACT when a register is produced, rather it is stored in the mIP/IPDACT local
configuration and is used for local events generated for this account number.
Syntax:
ARLY-1 Cfg> MIP accnt local-events-zone identifier-zone
identifier-zone This is a hexadecimal number of up to three digits.
Example: