SilentKnight VisorAlarm ARLY Interface - Manual (Page 42)

VISOR ALARM – ARLY Configuration
II - 37
Doc.DM359-I
Rev.2.0
calls
alarm-tx-retries Times MIP retransmmit an alarm before abandon
callback-phone Phone number Alarm Panel dials to make a
callback
bck-receiver-ip Public IP address which MIP uses to send
alarms to the backup VisorAlarm
bck-keep-alive-timer MIP keep-alive timer in seconds for backup
VisorAlarm
bck-keep-alive-retries MIP keep-alive num of retries for backup
VisorAlarm
bck-keep-alive-retries-time MIP time between keep-alive retries in
seconds for backup VisorAlarm
reset reset remote MIP
local-events-zone Zone number to use in locally generated
events
mnt-ip-address Maintenance IP address
mnt-password Password for maintenance alarms
local-ip-parameters IP parameters for MIP ethernet interface
pstn-action Action to be done in the MIP when PSTN fail.
subscriber-telephone The subscriber┤s telephone in whose premises
are the mIP installed.
last-update-time The date and time of the last MIP
configuration update
anti-substitution Enabling mechanism for detecting the MIP
substitution.
a) MIP accnt Default
Establishes the default configuration for the specified mIP/IPDACT. To completely delete an
mIP/IPDACT configuration, use the NO MIP accnt DEFAULT command.
Syntax:
ARLY-1 Cfg>MIP accnt DEFAULT
accnt mIP/IPDACT account number. This is composed of up to 6
hexadecimal digits (0 to 9, A, B, C, D, E and F). The range is from
000001 to FFFFFF.
Example:
ARLY-1 Cfg>MIP 101234 10 DEFAULT
ARLY-1 Cfg>
b) MIP accnt SERIAL-NUMBER
Configures the serial number that the mIP/IPDACT has associated to this account number. The
account number is used to certify that mIP/IPDACT associated to the said account is the correct one,
thus avoiding possible supplanting problems.
Syntax:
ARLY-1 Cfg>MIP accnt SERIAL-NUMBER serial_number
serial_number mIP/IPDACT serial number as shown on its label.
Example:
ARLY-1 Cfg>MIP 101234 SERIAL-NUMBER 8209/300
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command: