SilentKnight VisorAlarm ARLY Interface - Manual (Page 22)

VISOR ALARM – ARLY Configuration
II - 17
Doc.DM359-I
Rev.2.0
port_number Number of the UDP port used. Admits values between 1 and 65535.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 RECEIVER-UDP-PORT 20300
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command:
ARLY-1 Cfg>NO CFG-PATTERN n RECEIVER-UDP-PORT port_number
f) CFG-PATTERN n USR PASSWORD
Configures the mIP/IPDACT configuration / monitoring console password. This is applied to both the
asynchronous console as well as the telephonic console. This password can be dependent on the
account number: assuming the account number is represented through UVWXYZ, you can use these
to generate passwords using the serial number digits. In the example, if the account number is 01234
(X = 2, Y = 3 and Z = 4), then the password is 1223400B4.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n USR-PASSWORD password
password Password of up to 16 hexadecimal digits (0 to 9, A, B, C, D, E and F).
This also admits U, V, W, X, Y, Z.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 USR-PASSWORD 12XYZ00BZ
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command:
ARLY-1 Cfg>NO CFG-PATTERN n USR-PASSWORD password
g) CFG-PATTERN n MIP-PASSWORD
Configures the password with which the mIP/IPDACT encrypts its messages. This password can be
dependent on the mIP/IPDACT account number, in the same way as the above.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n MIP-PASSWORD password
password Password of up to 16 hexadecimal digits (0 to 9, A, B, C, D, E and F).
This also admits U, V, W, X, Y, Z
Example:
ARLY-1 Cfg>CFG-PATTERN 10 MIP-PASSWORD 12XYZ00BZ
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command: