SilentKnight VisorAlarm ARLY Interface - Manual (Page 25)

VISOR ALARM – ARLY Configuration
II - 20
Doc.DM359-I
Rev.2.0
ARLY-1 Cfg>NO CFG-PATTERN n KEEP-ALIVE-RETRIES-TIMER time
l) CFG-PATTERN n PHONE-LENGTH
In the mIP/IPDACT this configures the number of digits making up a telephone number. This number
depends on the country’s dialing plan, the existence of switchboards etc. The mIP/IPDACT uses this
to find out how many digits it should expect from the control panel before processing the call.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n PHONE-LENGTH length
length Number of digits making up a telephone number. Admits values
between 1 and 15.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 PHONE-LENGTH 9
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command:
ARLY-1 Cfg>NO CFG-PATTERN n PHONE-LENGTH length
m) CFG-PATTERN n ALARM-TX-RETRIES
Configures the number of times that the mIP/IPDACT sends an alarm to the VisorALARM to ensure
that this receives the alarm and sends confirmation to the mIP/IPDACT. Connection with is
considered lost once this number of retries has been completed and permits the control panel to send
the alarm over the telephone line.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n ALARM-TX-RETRIES number
number Number of times the alarm is sent to the VisorALARM. Admits
values between 5 and 10.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 ALARM-TX-RETRIES 5
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command:
ARLY-1 Cfg>NO CFG-PATTERN n ALARM-TX-RETRIES number
It is essential that the total time in which the mIP/IPDACT deactivates in cases where
communication between the two IP receivers is less than the highest time for retries
from the alarms panel.