Triton 8100 User/Installation Manual - Manual (Page 82)

64
M
ODEL
8100 U
SER
/ I
NSTALLATION
M
ANUAL
T
RITON
C
ONNECT
H
OST
N
UMBERS
(A
DDRESS
)
D
ESCRIPTION
:
The T
RITON
C
ONNECT
H
OST
N
UMBERS
are provided by the Triton Connect
Administrator. If you are using TCP/
IP as your communication type, you
will need to enter the Triton Connect
Host TCP/IP Addresses and Listening
Port information. The first part of the
address consists of a sequence of four
groups of numbers. Each group can be
up to three digits long and each group
is separated by a period (dot character),
as in this example: 123.3.01.99 The
second part of the address is a Port
Number, consisting of four (4) digits
or less, separated from the first part by
a comma (“,”) character, as in this
example: 123.3.01.99,9323. (No
Spaces!) The default Listening Port for
Triton Connect is ‘9323’.
Note: Comms Type Option
For Model 8100/9100 ATMs, this
function detects the communication
type installed (wireless) and will not
allow user to change (toggle).
Follow these steps to initially enter or
change the T
RITON
C
ONNECT
P
RIMARY
H
OST
N
UMBER
(A
DDRESS
):
$
Select to blank the current entry, if necessary.
$
Enter the first group of numbers in the TCP/IP Address using the main keypad
keys.
$
Enter a ‘dot’ character by pressing the key, then the <0> key Twice
to select the period’, then the key to lock it in.
$
Repeat Steps 2 and 3 for the second and third group of numbers in the TCP/IP
Address.
$
Enter the fourth group of numbers in the TCP/IP Address.
$
Enter the comma (“,”) character by pressing the key, then the <0>
key Once to select the comma. Press the key to lock it in.
$
Enter the Port Number. Select to save the Primary TCP/IP Address
entry or to discard the changes. Repeat steps for B
ACKUP
TCP/IP
A
DDRESS
, if needed.