Triton 8100 User/Installation Manual - Manual (Page 37)

19
M
ANAGEMENT
F
UNCTIONS
Figure 3-1. Main menu screen.
N
EW OR
M
ODIFIED
M
ANAGEMENT
F
UNCTIONS
The majority of the Management Functions are configured the same as before but
they may have been relocated in the menu structure. A brief synopsis of each
function is provided. A summary of the changes to the Management Functions is
provided below:
"
M
AIN
M
ENU
- Three (3) major configuration paths now exist: Terminal,
Services, and Processors. The other options (Cassette Service, Diagnostics, Close,
and Journal) have moved slightly but their functions remain the same.
"
D
IAGNOSTICS
- To reset an on-screen VEPP tamper error ‘205’ or VEPP
Serial number error ‘239’, you must traverse through the Diagnostics menu items. A
new option, “K
EYPAD
”, allows user to clear either of these 2 error codes.
"
Key Management - Two (2) passwords are now required before users can
enter the PIN Master keys option. Once accessed, two (2) key parts (32 number/
character stream) must be loaded, followed by a second part. The Check Digits are
displayed before either accepting or declining. An on-screen keypad directs users
for entering numbers and characters.
"
C
OMMUNICATION
- This menu item replaces the Telephone Configuration.
TCP/IP configuration setup is now included with the modem setup.
"
T
RITON
C
ONNECT
™ - Moved under “ATM Monitoring”. TCP/IP configu-
ration setup also included for Triton Connect. The communication type (dial-up or
TCP/IP) is automatically detected.
"
C
ONFIGURE
P
ROCESSORS
- Processor specific information is now config-
ured under this option. You may configure up to four (4) processors and select
which processor for individual WAVES services. Standard ATM cash transactions
WILL use processor number one (1) as its default.
"
S
URCHARGE
- You may now block up to one hundred (100) ISOs at the
terminal.