Triton 8100 User/Installation Manual - Manual (Page 47)

29
M
ANAGEMENT
F
UNCTIONS
2. Password Required - When “En-
ter Master Keys” is selected, you
will be prompted to enter two (2)
passwords. If this is an initial setup,
the default password is six (6) ze-
ros (000000) for each. You will
then be prompted to change pass-
words. Passwords MUST be
changed!
3. Change Password (Initial Setup) -
The VEPP requires that no default
password can be entered. If a user
enters the default password, the
VEPP will force the user to change
them before they can enter keys.
4. Change User Passwords (cont) -
This screen allows the user(s) to
select which password to change.
If any password is the default
value, the VEPP will only allow
these two functions to be selected.
5. Change User Passwords (cont) -
If this is an initial setup, the cur-
rent password will be six (6) zeros
(000000). Enter a new password
(twice). A password consists of six
(6) numbers, no characters. A
screen prompt will appear if the
passwords was changed success-
fully. DO NOT use weak pass-
words (Ex: 111111,123456)