Triton 8100 User/Installation Manual User Manual

Page 131

A-19

NSTALLATION

ROCEDURES

5. Stand the unit(s) up and walk them

out of the shipping carton.

6. Remove the wrapping from the

ATM.

7. Use the silver key to unlock both

the control panel and the fascia
door (which conceals the locking
mechanism) on the front of the
cabinet. Open the fascia door.

8. Turn the knob to open the front

enclosure door. If the door is
locked, open with the vault door
key included or see the sidebar on
this page for help in unlocking the
electronic or mechanical lock, if
applicable..

9. Remove the packing material from

inside the vault enclosure. Next,
carefully remove the dispensing
mechanism. Inspect the dispenser
and report any damage to Triton.
Set the mechanism aside. This will
be installed in later steps.

10. The accessory box is shipped

inside the plinth enclosure. Open
and inspect the contents. Check
the contents against the enclosed
packing list and report any missing
parts to Triton.

The next procedures are for anchoring
the plinth.

UNLOCKING

COMBINATION LOCKS

Mechanical Lock. There are two
marks on the dial ring. The index
mark at the top of the dial is used
for opening the lock. A revolution
is counted each time the selected
number is aligned with the open-
ing index.
Locks are shipped on a factory set-
ting of ‘50’. To unlock, turn the
dial to the left (counterclockwise)
FOUR (4) turns, stopping on ‘50’.
Then turn the dial to the right
(clockwise) until the bolt is re-
tracted.

Electronic Lock. The combination
of the lock is preset to 1-2-3-4-5-
6. To unlock, enter the preset com-
bination and check for proper op-
eration. After each keypress, the
lock will ‘beep’. After the final digit
has been entered, the lock will beep
twice, and the open period begins.
When a valid combination has
been entered, the operator will have
approximately 3 seconds to open
the lock. To open the lock, turn
the outer ring of the dial clockwise.
After the lock is opened, the vault
door may be opened.