Triton 8100 User/Installation Manual - Manual (Page 141)

A-29
I
NSTALLATION
P
ROCEDURES
Figure 4. Align slots of dispenser
under screws.
4. Place the TDM-50 on the
mounting tray with the cassette
facing into the security cabinet.
Align and slide the slots on the
rear bottom of the dispenser under
the two (2) screws previously
installed (Figure 4). 5. Install the two (2) front phillip
screws back into the holes at the
front of the dispenser shown in
Figure 5. Tighten all the screws.
Figure 5. Install front mounting
screws.
6. Connect the dispenser data, power,
and ground wire cables to their
respective connections on the left
side of the TDM-50 (Figure 6).
Data cable
Power cable
Ground wire
Figure 6. Dispenser cable connections.