Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 75)

Multi-Service IronWare QoS and Traffic Management Configuration Guide 61
53-1003037-02
Egress port and priority based rate shaping
3
To change the profile from strict to weighted WRR0, use the qos scheduler WRR0 command on the
interface (in this case you would change it on the Outgoing interface ie 1/13. Remember, on the
Brocade NetIron CES and Brocade NetIron CER the QOS Scheduler is on Egress interface only.
Brocade(config)#sh run int e 1/13
interface ethernet 1/13
qos scheduler profile WRR0
enable
To change the settings of weighted WRR0, use the qos scheduler profile WRR0 command in global
config mode.
Brocade(config)# qos scheduler profile WRRO weighted 40 10 20 30 40 50 60 10
Syntax: qos scheduler profile
Issue the show qos scheduler profile command to verify the change.
Brocade#show qos scheduler profile
Index | Scheme Type Pri7 Pri6 Pri5 Pri4 Pri3 Pri2 Pri1 Pri0
-------+----------------+------+------+------+------+------+------+------+----
0 | Strict
1 | WRR0 Weight 40 10 20 30 40 50 60 10
2 | WRR1 Weight 10 10 10 10 10 10 10 10
3 | WRR2 Weight 10 10 10 10 10 10 10 10
4 | MIXED0 Weight 100 80 60 40 20
5 | MIXED1 Weight 20 40 60 80 100
6 | MIXED2 Weight 30 30 30 30 30
7 | MIXED3 Weight 128 128 1 1 1
Syntax: show qos scheduler profile
Clearing traffic manager statistics
You can clear statistic for a Brocade device as shown in the following.
Brocade# clear statistics
Syntax: clear statistics
Network processor counters displayed
Output from the show interface command has been enhanced to provide the following related
information:
• The number of packets received at the network processor (NP)
• The number of packets sent from the NP
• The Number of ingress packets dropped at the NP
• The number of packets transmitted from the NP
• The number of packets received by the NP
The following is an example of the new output from the show interface command.
Brocade(config)# show interface ethernet 3/3
GigabitEthernet3/3 is up, line protocol is up
Hardware is GigabitEthernet, address is 0004.80a0.4052 (bia 0004.80a0.4052)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Member of L2 VLAN ID 1, port is untagged, port state is Forwarding