Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 109)

Multi-Service IronWare QoS and Traffic Management Configuration Guide 95
53-1003037-02
Configuring QoS
4
Brocade(config)# qos pcp decode-policy Customer1
Brocade(config)# interface ethernet 10/1
Brocade(config-if-e10000-10/1)qos pcp decode-policy Customer1
Syntax: [no] qos pcp decode-policy decode-map-name | default-map | all-zero-map | 7P1D
|6P2D | 5P3D
The decode-map-name variable is the name assigned to the Ingress Decode PCP Policy Map that
you want applied to the port whose configuration this is under.
The default-map option assigns the default Ingress Decode PCP Policy Map to the port whose
configuration this is under. Since the default Ingress Decode PCP Policy Map is the default setting,
this option is only required when the device’s global map has been set to an Ingress Decode PCP
Policy Map other than the default.
The all-zero-map option assigns an Ingress Decode PCP Policy Map where all PCP values are
mapped to priority 0 and drop precedence 0. This is useful if you do not want to process any PCP
information in the incoming packet.
The 7P1D option assigns the 7P1D Ingress Decode PCP Policy Map to the port whose configuration
this is under.
The 6P2D option assigns the 6P2D Ingress Decode PCP Policy Map to the port whose configuration
this is under.
The 5P3D option assigns the 5P3D Ingress Decode PCP Policy Map to the port whose configuration
this is under.
NOTE
7P1D, 6P2D, and 5P3D are as defined in the IEEE 802.1ad specification and described in Table 19 .
Binding an Ingress decode EXP policy map
The following procedures describe how to configure the binding of an Ingress Decode EXP Policy
Map:
• Globally Binding an Ingress Decode EXP Policy Map.
• Binding an Ingress Decode EXP Policy Map to a Port.
Globally binding an Ingress decode EXP policy map
You can bind an Ingress Decode EXP Policy Map globally for a Brocade device using the qos exp
decode-policy command as shown in the following.
Brocade(config)# qos exp decode-policy Customer1
Syntax: [no] qos exp decode-policy decode-map-name | default-map | all-zero-map
The decode-map-name variable is the name assigned to the Ingress Decode EXP Policy Map that
you want applied globally on the device. If you try to apply a decode-map-name value that has not
been defined, the configuration will be rejected. If the decode-map-name value that has been
defined but the policy has not been configured, the configuration will be accepted and the
default-map will be applied.
The default-map option assigns the default Ingress Decode EXP Policy Map globally on the device.
Since the default Ingress Decode EXP Policy Map is the default setting, this option is only required
when the device has been previously set to a different Ingress Decode EXP Policy Map.