Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 160)

146 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Traffic manager statistics display
4
Clearing traffic manager statistics
You can clear traffic manager statistics selectively for a specified port group, selectively for an
interface module, or for an entire Brocade device as shown in the following.
Brocade# clear tm statistics ethernet slot 4
Syntax: clear tm statistics [ ethernet slot/port | slot slot-number ]
Executing the clear tm statistics command without any options clears all traffic manager statistics
on the device.
The ethernet slot/port option specifies a port group that you want to clear traffic manager statistics
from.
The slot slot-number option specifies an interface module that you want to clear traffic manager
statistics from.
New network processor counters displayed for
packets to and from traffic manager
Output from the show interface command has been enhanced to provide the following traffic
manager related information:
• Number of packets received at the network processor (NP)
• Number of packets sent from the NP to the traffic manager (TM)
• Number of Ingress packets dropped at the NP
• Number of packets transmitted from the NP
• Number of packets received by the NP from the TM
The following is an example of the new output from the show interface command with the changed
output highlighted in bold.
Brocade(config)# show interface ethernet 3/3
GigabitEthernet3/3 is up, line protocol is up
Hardware is GigabitEthernet, address is 0004.80a0.4052 (bia 0004.80a0.4052)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Member of L2 VLAN ID 1, port is untagged, port state is Forwarding
STP configured to ON, Priority is level0, flow control enabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
MTU 1544 bytes, encapsulation ethernet
300 second input rate: 754303848 bits/sec, 1473249 packets/sec, 89.57% utilization
300 second output rate: 754304283 bits/sec, 1473250 packets/sec, 89.57%
Current Queue Depth Shows the current queue depth.
Maximum Queue Depth
since Last read Shows the maximum queue depth since last access to read.
TABLE 37 Output parameters of the show tm-voq-stat src_port eth 3/21 fid 8004
command (Continued)
Field Description