Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 53)

Multi-Service IronWare QoS and Traffic Management Configuration Guide 39
53-1003037-02
Rate limiting ARP packets
2
Clearing Statistics for ARP Rate Limiting
You can clear ARP Rate Limiting Statistics using the following command:
Brocade# clear rate-limit arp
Syntax: clear rate-limit arp
Re-mark The ARP traffic in bytes whose priority have been remarked as a result of
exceed the bandwidth available in the CIR bucket for the ARP rate limit
policy since the device was started up or the counter was reset.
Total The total ARP traffic in bytes that has been subjected to the ARP rate
limit policy since the device was started up or the counter was reset.
TABLE 13 Rate limit ARP display parameters
Parameter Description