Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 130)

116 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Displaying QoS information
4
Displaying QoS Binding configurations
To display QoS Binding configuration information, enter the following command at any level of the
CLI.
Syntax: show qos-map binding global | slot/port
The global option is used to display all QoS Policy Map bindings configured on the device.
The slot/port variable is used to display all QoS Policy Map bindings configured on the device.
Displaying QoS packet and byte counters
You can enable and display the collection of statistics for Ingress and Egress packet priorities as
described in the following sections:
• Enabling QoS Packet and Byte Counters
• Displaying QoS Packet and Byte Counters
• Clearing QoS Packet and Byte Counters
Enabling QoS packet and byte counters
You can enable the collection of statistics for Ingress and Egress packet priorities using the
enable-qos-statistics command as shown in the following.
Syntax: [no] enable-qos-statistics
The default for this command is disabled.
Using the no option returns a previous enabled configuration to the default disabled state.
Brocade(config)# show qos-map binding global
qos pcp decode-policy pcp-t2
qos exp decode-policy exp-t1
qos dscp decode-policy dscp-t3
qos dscp encode-policy dscp-d3
Brocade(config)# enable-qos-statistics
Brocade#