Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 48)

34 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
IPv6 ACL-based rate limiting
2
Configuring rate-limit using non-existing access-list
Rate-limiting can be configured using a non-existing or empty IPv6 access-list. When the access-list
is created or when filters are added to the access-list and an explicit rebind is performed, the
rate-limit parameters will be programmed on the interface.
Output of show commands to verify output
Following is the output of the debug commands to confirm the configuration and functionality.
Display Rate-Limit Configuration
Brocade# show rate-limit
interface e 1/1
rate-limit input access-group name ipv6 fdry 993568 2000000
Display CAM contents for IPv6 access-list
Brocade#show cam v6acl 4/2
LP Index Src IP Addr SPort IFL/VLAN ID
Dst IP Addr DPort Pro Age Out IF PRAM
4 b4000 ::/0 0 N/A
::/0 0 0 Dis Pass 000a8
4 b4008 ::/0 34816 N/A
::/0 0 58 Dis Pass 000a9
4 b4010 ::/0 34560 N/A
::/0 0 58 Dis Pass 000aa
4 b4018 ::/0 0 N/A
::/0 0 0 Dis Drop 000ab
Display rate-limit configurations
The following show command displays the rate limit configuration on an interface.
Syntax: show rate-limit interface slot/port input | output access-group {acl_id | name {mac |
ipv4 | ipv6}} acl_name
Display Rate-limit counters
The following show command displays rate-limit counters on an interface.
Syntax: show rate-limit counters interface slot/port input | output access-group {acl_id | name
{mac | ipv4 | ipv6 } acl_name}
Display Access-list accounting for rate-limiting
The following show command displays rate-limit accounting for an IPv6 ACL.
Brocade(config)# show ipv6 access-list accounting eth 1/1 in rate-limit
Syntax: show ipv6 access-list accounting slot/port input | output in rate-limit