Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 218)

204 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Hierarchical QoS (HQoS) for 8x10G modules
5
Scheduler and queue policy configuration templates
Scheduler and queue policy configuration templates are available for creating the HQOS tree.
The configuration does not come into effect till they are bound to a interface supporting HQOS.
Once a policy is bound to an interface, you cannot make any changes to the policy (except shaper
rate and burst size). The policy has to be unbound and then make the changes to the policy and
rebind it.
The queues can be connected to any of the following levels (3, 2 or 1). It cannot be connected to
level 0 directly.
The same policy can be applied to multiple interfaces.
HQOS scheduler policy configuration template
[no] hqos scheduler-policy level |
level-0 | level-1| level-2 | level-3
[no][shaper-rate ]
[no] [shaper-burst-size ]
[no]{scheduler-type | scheduler-type-other} | strict |
weighted | mixed
[no]{scheduler-flow {scheduler-input
} | [weight ] scheduler-policy
}
HQOS Queue policy configuration template
[no] hqos queue-policy
[no] [shaper-rate ]
[no] [shaper-burst-size ]
HQOS mapping template.
[no] hqos-map
[no] [shaper-rate ]
[no] [shaper-burst-size ]
[no] [match other] |
[no] [{match vlan } | [inner-vlan | isid
] ]
HQOS policy binding to an interface
interface ethernet /
[no] hqos service-policy output