Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 166)

152 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Aggregated TM VOQ statistics collection
4
Displaying TM statistics from the multicast queue
Use the following command to display traffic manager statistics from the Multicast queue for
priority 1 on a module.
Brocade# show tm-voq-stat src_port eth 4/1 multicast 1
Priority = 0/1
EnQue Pkt Count 0
EnQue Bytes Count 0
DeQue Pkt Count 0
DeQue Bytes Count 0
Total Discard Pkt Count 0
Total Discard Bytes Count 0
Oldest Discard Pkt Count 0
Oldest Discard Bytes Count 0
WRED Dropped Pkt Count 0
WRED Dropped Bytes Count 0
Current Queue Depth 0
Maximum Queue Depth since Last read 0
Syntax: show tm-voq-stat src_port source-port multicast priority | all
Specification of a source-port is required.
You can optionally specify a priority to limit the display to a single priority or use the all parameter to
display all priorities.
Showing collected aggregated TM VOQ statistics
Aggregated counters are the aggregation of counters from all ingress TMs to a specified
destination port. Use the show tm-voq-stats dst_port command to display aggregated counters for
each port.
Brocade# show tm-voq-stat dst_port ethernet 8/1 4
Port Enqueued (pkts) Dequeued (pkts) Dropped (pkts)
(bytes) (bytes) (bytes)
-------------------------------------------------------------------------------
8/1 :
P4 : 1277236787 1377236787 0
198322097328 198322097328 0
Syntax: show tm-voq-stats dst_port [ethernet slot/port | all ] [ priority | all ]
The slot/port variable specifies the slot and port number of the port group from which you want to
display Traffic Manager statistics. The all option displays TM statistics for all ports.
The P variable specifies the priority for which you want to display Traffic Manager statistics. The all
option displays TM statistics for all priorities.
The following combinations of the command can be used to display Traffic Manager statistics:
• Use the show tm-voq-stats dst_port ethernet slot/port P command to display priority P
counters for the slot/port.
• Use the show tm-voq-stats dst_port ethernet slot/port all command to display aggregated and
all priorities counters for the slot/port.
• Use the show tm-voq-stats dst_port ethernet slot/port command to display aggregated
counters for the slot/port.