Nexo NEMO - Manual (Page 47)

NEXO NeMo User Guide v1.3
Page 47 of 50
APPENDIX A: ACCESSIBLE NXAMP’S PARAMETERS
Name Description Control in Nemo Log Alert
Load Version of the NXAMP’s firmware. Network and Setup
tabs (read only)
Inpatch (per ch.) Patching between analog (A to D) and
network (E to H) inputs and processing
channels (1 to 4).
Control tab
Volume (per ch.) Volume (in dB) of a channel. Control tab
Delay (per ch.) Delay (in ms, s or ft) of a channel Control tab
Gain (per ch.) Gain (in dB) of a channel. There is no
difference between gain and volume
setting. The amplifier automatically
combines digital or analog gain to optimize
the dynamic range.
Control tab
Array EQ (per ch.) Gain (in dB) of a low or high shelving filter
whose cutoff frequency is fixed, depending
on the current setup. You can use Array EQ
to compensate ground/stacking or line
array effects.
Control tab
Headroom (per
ch.)
Reduction (in dB) of the gain sensitivity
range to enhance the analog to digital
conversion, and thus improve background
noise and reduce distortion. More often set
to 0dB. You may want to reduce the
headroom in case of quiet sound, if so mind
to check the clipping.
Control tab
Cabinet (per ch.) Name of the cabinet associated to the
channel.
Control tab (read
only), Setup tab
Setup number Index of the current standard setup (preset
adapted to a combination of cabinets).
Setup tab (standard
panel)
Custom setup
descriptors (per
ch.)
Set of series / cabinet / cabinet mode /
crossover mode adapted to the loudspeaker
associated with a channel (or a couple of
channels if bridge).
Setup tab (Custom
panel)
Scene number Index of the last scene that has been
recalled (a scene is a saving of the settings
of a NXAMP: patch, volume, delay,… and
setup).
Scene tab
Stand-by Stand-by mode of the NXAMP: if on, the
large power supplies used by the power
amplifiers are turned off, and the controller
is put in a low power mode. No control is
then available in Nemo, except exiting the
stand-by mode.
Control tab  
Mute (per ch.) Mute status of a channel. Network and Control
tab

Overmute/Global
mute
Mute status of the four channels. If
overmute is active, the channels’ mute
status is preserved. In Nemo, overmute is
active if the four channels are muted.
Network and Control
tab

Input level
(analog)
Peak level (in dBFS) at the output of the
analog to digital converter of an analog
input (A to D). Given with an accuracy of
±3dB, and at a maximum rate of 25Hz.
Network tab (map of
the groups only) and
Control tab

Input level
(network)
Peak level (in dBFS) of a network (E to H)
input. Given with an accuracy of ±3dB, and
at a maximum rate of 25Hz.
Network tab (map of
the groups only) and
Control tab
