Nexo NEMO - Manual (Page 24)

NEXO NeMo User Guide v1.3
Page 24 of 50
Cabinet
It is a read-only value. To set it, go to the Setup tab.
Multiple values
If several devices are selected, then a channel represents this channel for
all the selected NXAMPs. Therefore, multiple values are possible, for
instance if channel 2 of a selected NXAMP is muted, and channel 2 of
another selected NXAMP is not. Multiple values are displayed the following
way:
 Patch: links are green. Dragging your finger along a green link
provokes the removal of the link.
 Gain, Array EQ, Headroom, Volume: the slider is green. The displayed
value is the average. Moving the slider to a value sets all the values to
the slider's value if the Absolute Mode is active, or add the same
amount to the different values if the Relative Mode is active.
 Delay: the displayed value is Mult.. Setting a new value sets all the
values to the text field's value. Dragging your finger in case of multiple
values have the same behavior as Gain, Array-EQ…
 Delay unit: the button's label is Mult.. Tapping on the button sets all the
values to its new value.
 Mute-Solo, Overmute-solo, Stand-by: these buttons are green. Tapping on a
green button selects the button. For instance: becomes . If
multiple Stand-by, no other setting is accessible.
 VU-meters: VU-meters display the maximum value, but do not have a
special color.
 Cabinet: the value Multiple is displayed.
Setting parameters of several channels
It is possible to change simultaneously the value of delay, volume, gain,
headroom or array-EQ of 2 to 4 channels of the selected NXAMPs.
iPhone users only:
To change the value of a parameter of several channels simultaneously, tap
on these channels, as explained above (
Setting parameters). Modifications can
be absolute or relative.
iPad users only:
Tap on the check boxes of the channels to edit simultaneously.
Tip: You can select or deselect several channels with a single gesture, by
taping on a check box , and then sliding your finger over the other